Stock FAQs

what is stock gm 5.7 thermostat temp

by Godfrey Hyatt Published 3 years ago Updated 2 years ago
image

Full Answer

Is the stock thermostat temperature worth it?

The stock thermostat temp is better for fuel economy and emissions. Also better for running the heater in cold climates. Something the majority of people want. The engine makes more power at lower temps...something the minority of customers want or care about. The stock thermostat temp is better for fuel economy and emissions.

What temp should the thermostat be set at?

The factory thermostat is not designed to be fully opened to 220º, so the radiator won't always be keeping the temp at 203º (for a 203º thermostat for example). I think there are two stages for the radiator fans, low speed on at around 209º, high speed on around 219º.

What should the operating temp be on a hemi?

Ok, well we know the operating temp for your Hemi should be 203°F, a few degree higher than most motors, but that is the figure you should see plus/minus a few degrees. Nav/Computer readings? So you're using the OEM Nav Radio that has a feature to read out some engine data?

What is the water temp on a Chrysler engine?

Just about all Chrysler Engines that is 191°F to 195°F. There are spots in the water jacket that the actual water temp will vary, so some aftermarket water temp gauges that have the sensor installed in water jacket drain plugs or freeze plugs may show a different temp than is measured for the PCM or the gauge on the dash.

image

What temp should a 5.7 Vortec run at?

195 degree thermo is what you want to use because the ECM will send the system into a "full rich" condition if you go to the 180.

What temperature should my truck thermostat be?

The thermostat you should use in your vehicle is a 170 degree for summer and 180 degree for winter. If you need further assistance with changing your thermostat, then seek out a professional, such as one from Your Mechanic, to help you.

What temp should my SBC run at?

180-200 is a good range for carbed motors, 190-210 for EFI motors. If you run too cold, you get worse fuel efficiency, your motor oil becomes acidic due to not vaporizing the stuff out that needs to be vaporized, and your exhaust system may not last as long due to increased condensation.

Is 180 degree thermostat better?

A 180-degree thermostat is better for engine efficiency—aka better fuel mileage and decreased emissions. A 160-degree thermostat is designed to maintain a lower engine operating temperature, which tends to make a little bit more horsepower and torque.

Is 230 degrees to hot for an engine?

For most cars, the normal operating engine temperature is in a range of 195 to 220 degrees Fahrenheit, though most dashboard temperature gauges don't show an exact temperature. Instead, there are typically markings for cold and hot on the edges of the gauge and a normal range in the middle.

Is 210 degrees too hot for an engine?

210 on stock gauge should be fine... The gauges aren't usually 100% accurate. It is when you get above 210 when you may run into problems.

How hot is too hot for engine coolant?

Normal operating temperature of new and used vehicles Of course, factors such as air conditioning, towing and idling at a stop will impact this, but you should be fine if your car is running at anywhere between 190-220 degrees. Over this limit, and your radiator and coolant fluids run a higher risk of burning.

What can cause a 350 small block to overheat?

A common SBC overheating issue is airflow over the radiator being blocked by a number of materials. Dirt, dust, leaves, and even insects that pass through a car's front grille will get stuck on the vanes and thin metal plates that make up a radiator's design.

How do you install a water temperature gauge on a small block Chevy?

1:214:24Water Temperature Gauge Install ( Chevy 350) - YouTubeYouTubeStart of suggested clipEnd of suggested clipNow because this the old one I'm just gonna cut it right like that and push it throw. And thenMoreNow because this the old one I'm just gonna cut it right like that and push it throw. And then loosen it from underneath. So this is gonna go in there like that. And this is gonna go up in the back.

Is a 160 thermostat too cold?

You should be fine with just the 160. You dont need to drill it. It will run alot cooler with it in anyways. No it is not too cold, the engine can still get to closed loop in winter.

Will a lower thermostat help overheating?

A low-temp thermostat gives the cooling system a head start. This will help to prevent Engine Detonation and overheating.

Does a cooler engine run better?

Performance vehicles move parts even quicker, from engine internals, to transmission gears, to differentials, only making components hotter. Cooling temperatures throughout the drivetrain will not only keep a car running longer, but will potentially help it run quicker.

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9