Full Answer
Will a CETME wood stock fit a Cal 308?
Spanish CETME wood stock set. This set will fit the Century Arms rifle Cal 308. Used condition. Hand guard screw NOT included. GERMAN ARMY HK91/G3 WOOD STOCK WITH BUTT-PLATE.
How do you finish a stock with satin finish?
Using a piece of wire, hang your stock in a dust free area, where the center of the stock is at shoulder level, or a height that insures you can easily spray all areas of the stock. Spray a coat of Polyurethane Satin Finish.
How do you stain walnut stock?
If your stock has a buttplate, leave attached and you can finish the plate along with the rest of the stock. Sapwood or lighter areas are common in walnut. Using a soft rag, and Walnut Stain lightly dab these areas of the stock to blend colors together.
How long does it take for wood stock to dry?
Allow stock to dry for 12 hours. Using the 320 grit sandpaper, sand stock to a smooth finish. If you discover open pores in the wood, repeat step 9 and 10. Using a soft brush, clear all the dust from the inletting area. Using the tack cloth, wipe debris from the stock.
How to get rid of dark wood stain?
(Note when you are finished with the rags, soak in water, and dispose of in outside container.) In a circular motion, apply a coat of Woodfill.
How to remove woodfill from stock?
With a piece of burlap or a coarse rag, remove the woodfill from the stock in a cross grain motion. Insure there is no woodfill left on the surface, or in the inletting. Allow 24 hours to dry. Using a soft brush, clear all the dust from the inletting area. Using the tack cloth, wipe debris from the stock.
How to remove scratches from wood stock?
Sanding with the grain, remove all rough wood and blemishes in your stock. Repeat this process with the 150 grit removing the 120 grit scratch pattern. Again, repeat this process with the 180 grit removing the 150 grit scratch pattern.
How to hang a stock in a dust free area?
Using a piece of wire, hang your stock in a dust free area, where the center of the stock is at shoulder level, or a height that insures you can easily spray all areas of the stock. Spray a coat of Polyurethane Satin Finish. (First read directions on can.) Allow stock to dry for 30 minutes. Repeat step 11.
How to hang a stock with buttplate?
If your stock has a buttplate, leave attached and you can finish the plate along with the rest of the stock. Using a piece of wire, hang your stock in a dust free area, where the center of the stock is even with your shoulders, or a height that insures you can easily spray all areas of the stock.
How long does it take for a finish coat to dry?
Allow 15 to 20 minutes for finish to soak into material, and repeat step 6. Allow stock to dry for 12 hours. Repeat step 6, and while stock is still wet, ...
