- Determine what the footprint of the stock is going to be once you cut it off and find an aftermarket recoil pad to fit it. ...
- Leave a foot. Just cut the stock and re-attach the pad. ...
- Use a "grind to fit" pad. This is the option used by most gunsmiths when shortening stocks, and they mostly do a s___ty job of it. ...
How do you cut off an inch off a stock?
I decided to cut off an inch. I use a scribe to mark the new length all the way around the stock. My scribe has a razor edge, which will help prevent splintering; alternatively, the stock can be wrapped with tape prior to cutting. The stock is then aligned in the miter saw.
Can you shorten the stock on a shotgun?
Shortening a shotgun stock and fitting a recoil pad. A shortened stock is one of the more common firearm modifications encountered. Often a shooter will need a shorter length-of-pull because he or she has a smaller frame, is younger, or wants a faster handling firearm. In some applications, such as law enforcement,...
What do you use to mark stock length?
I use a scribe to mark the new length all the way around the stock. My scribe has a razor edge, which will help prevent splintering; alternatively, the stock can be wrapped with tape prior to cutting.
How do you remove the stock bolt from a Remington shotgun?
The shotgun is safe and empty. This special Magna-tip bit allows removal of the recoil pad screws without damaging the pad. A large, flat-blade screw driver is used to remove the stock bolt. I decided to cut off an inch. I use a scribe to mark the new length all the way around the stock.
Can I cut down a shotgun stock?
1:202:58How to Shorten a Stock to Change the Length of Pull - YouTubeYouTubeStart of suggested clipEnd of suggested clipNow trick I learned a long time ago was to make a starting cut down in the toe line and then finishMoreNow trick I learned a long time ago was to make a starting cut down in the toe line and then finish it from the top and this helps you avoid chip outs as you finish the cut.
What length of pull do I need?
Measure the space between the recoil pad of your rifle and the crease of your elbow. Leaving approximately a ½-inch gap, the remaining length is what you will need for your proper LOP. For example, Josh is approximately 6 foot 3 inches tall and shoots a 14.25-inch LOP.
What is a short length of pull?
There should be a one to one and half inch gap or about two finger widths of space between your nose and thumb. If there is more space than that, the length of pull is too long. If there is less space, the length of pull is too short.
What does LOP mean in shotguns?
A: Length of Pull (LOP) on the shotgun or rifle is the distance from the trigger to the back center of the butt plate or recoil pad. LOP is one of the primary measurements in determining if the gun “fits” the shooter.