Full Answer
How do you remove the forward screw on a stamped AK?
Feb 09, 2013 · fast'n dirtyhttp://unboxingexperience.blogspot.com/http://on.fb.me/unboxingexperience
What are the different parts of the AK stock?
Always start by unloading the rifle-- Remove magazine and clear the chamber, then keep ammunition away from the work area. Buttstock Field strip the rifle: Remove dust cover, carrier spring and bolt carrier assembly. Find a screwdriver that fits the buttstock screw slots perfectly (this is important) and remove the buttstock screws.
How to trim the forend tenon on an AK?
Jan 05, 2012 · " CAUTION LOUD"just the simple way i used to remove my factory stock..had this video uploaded on my old channel but cant accsess the old profile so im reup...
How do I remove the buttstock from my rifle?
Dec 21, 2000 · After turning the lever, pull the lower handguard toward the muzzle to remove it. To remove the wood from the upper handguard/gastube: put the square end of the upper handguard/gastube assembly in a vise to prevent it from rotating, grab the wood portion and rotate your hand, the wood will slip right off the gastube.
Where is the forend retaining lever on a rifle?
You can now access the forend retaining lever at the right-hand inside edge of the forend cap. Use a flat bladed screwdriver to pry the retaining lever up and around 180 degrees, so that it points toward the muzzle (figure 9). If your rifle has a stowed cleaning rod, make sure it is removed at this time.
How to replace a pistol grip on a rifle?
With the rifle field stripped, unscrew the pistol grip bolt and remove the grip. Be sure the grip nut is in the receiver so that it slants backward at the bottom (figure 6). Place the grip bolt into the new grip. Holding the grip nut in the receiver with your finger, insert the grip bolt and get the threads started (figure 7).
How to lock gas tube?
Using a wrench or a bench vise, gently lock across the flat side portions in back of the gas tube. Grab the handguard firmly and rotate it around the gas tube axis until it is exactly upside-down (figure 13).
What to do if you can't get the screw in all the way?
Be safe. If you find that you cannot get the screw(s) in all the way, you may need to drill a larger and/or deeper hole. UltiMAK sells a number of fixed, telescoping, and folding buttstocks, complete stock sets, and individual components here, so you can put together your own custom configurations. Pistol Grip.
Is a tight stock fit in a rear trunnion good?
A tight stock fit in the rear trunnion is a good thing - the screws shouldn't be the only load bearing part holding the stock in place.
Does a mallet work with Arsenal stock?
A mallet worked for me before with Arsenal stocks, but not with my Vepr-FM. The dowel and hammer method was just punching a hole in the stock too. This solved the problem:
