Disconnect the stereo wiring connectors from the outlets on the back of the stock stereo. Unplug the antenna cable from the FM antenna input on the lower-right corner of the stereo unit. Use the trim panel removal tool to pry off any panels that are not easily removed by hand.
How long does it take to remove the stock stereo?
For one, they are very easy to remove, thanks to a simple bolt-in system. Taking out the stock stereo can take about five minutes to do, but if you do this frequently, you should be able to do it in under a minute. Better yet, it doesn't require any special tools, other than a 1/4-inch ratchet and the keys to the ignition.
How to remove car stereo without tools?
As always, we begin the how to remove car stereo without tools guide by disconnecting the battery’s terminals. This is the most important safety precaution. If you forget to do it, the consequences can be pretty dire. I’m talking about a short circuit, or even shock.
How to replace a stereo trim?
As for the required tools, a flathead screwdriver, a pry bar, a socket wrench, and a pair of protective gloves are the only equipment you’ll need for today. Popping off the Trim With that out of the way, move on to the stereo’s trim. It’s just a piece of plastic covering the stereo unit and will be secured with a pair of bolts or screws.
How do you remove the antenna from a car stereo?
Unbolt the stereo from the dashboard using the 1/4-inch ratchet and socket. Slide the deck out with your hands, then reach around to the back of the stereo and unplug the antenna lead and wiring harness. Russell Wood is a writer and photographer who attended Arizona State University.
How do you remove a factory fitted car stereo?
How to Remove a Factory Car StereoLocate the screws that hold the dash plate in place. Then, use the appropriate screwdriver to remove them by turning them counterclockwise until they come out of the holes. ... Remove the stereo bolts. ... Put your hand behind the stereo and grasp the antenna wire. ... Disconnect the power.
How do you get a factory radio out?
3:075:03How to remove a car stereo from your dash board - YouTubeYouTubeStart of suggested clipEnd of suggested clipThat's as simple as it is pull up the trim ring expose. The sleeve insert the keys pull out the unitMoreThat's as simple as it is pull up the trim ring expose. The sleeve insert the keys pull out the unit.
How do I remove a stereo without a tool?
1:466:00How to remove a car radio without special tools ( keys ) e.g. sony cdx ...YouTubeStart of suggested clipEnd of suggested clipYou just like pull something thin and hard underneath it and you can like feel that air like thisMoreYou just like pull something thin and hard underneath it and you can like feel that air like this metal pieces. This will a metal piece are like a little bit out. So you can just pull it out.
How do you remove a stereo system?
Pop off the stereo trim with a flathead screwdriver. Insert a flathead screwdriver under the trim and gently work around it to loosen it. Pull the trim off when it pops free. If the trim is stuck, you may have missed a screw or bolt. Double check and remove anything holding the trim down.
Can I install a subwoofer with a stock radio?
Adding a subwoofer to a factory stereo is an excellent method to boost your sound while retaining your factory controls. The nifty devices can produce bass and sub-bass sounds at low frequencies. Thankfully, it's pretty simple to wire one into an existing car stereo system.
Can I replace my factory radio?
any of today's vehicles have factory radios that either cannot be replaced or that we just don't recommend replacing. In this article, we'll take a look at why those radios are the way they are, and what you can do to improve the audio quality in your car or truck.
How do you remove a Ford stock radio without tool?
0:562:24Ford Radio Removal- NO SPECIAL TOOLS - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo what you can use instead is thick coat hangers and you get two got coat hanger I cut pieces offMoreSo what you can use instead is thick coat hangers and you get two got coat hanger I cut pieces off straight pieces down to about six inches. Put each one of the slots.
How do you remove a double din stereo?
0:336:32How to Remove Double Din Stereo - Audi A4 S4 RS4 - B6 B7 - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo as you can see got a straight edge on one side in the curved edge with a notch on the other.MoreSo as you can see got a straight edge on one side in the curved edge with a notch on the other. These can be brought to there fairly inexpensively on ebay.
How do you unplug car radio wires?
0:201:08Disconnecting the Wiring Harness for Car Stereo Installation - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd insert it into the wiring. Harness. Until it breaks free there after that we can go ahead. AndMoreAnd insert it into the wiring. Harness. Until it breaks free there after that we can go ahead. And remove that metal cage. The back of this speaker is a big magnet.
How do I remove a Kenwood car stereo?
5 Steps To Remove Kenwood Car Stereo With KeysStep 1: Turn off the car and stereo. ... Step 2: Detach the frame. ... Step 3: Slide the Stereo Removal Keys. ... Step 4: Pull the keys. ... Step 5: Disconnect the wires. ... Step 1: Turn off the car and disconnect the battery. ... Step 2: Remove the front lid of the Stereo. ... Step 3: Use two flat tools.More items...•
How do I take the speakers out of my car?
0:052:53HOW TO REPLACE CAR SPEAKERS - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe are going to remove the speaker wires from the positive and negative terminals. And then yourMoreWe are going to remove the speaker wires from the positive and negative terminals. And then your speaker will be completely disconnected from the housing. And the bracket.
How do you remove a Pioneer head unit?
1:502:50How to remove a Pioneer radio from its mounting cradle - YouTubeYouTubeStart of suggested clipEnd of suggested clipWell you gotta just push little tab out from the cradle that hooks into the radio. And like grabMoreWell you gotta just push little tab out from the cradle that hooks into the radio. And like grab this CD player and pull it out.
What is a stock radio?
In many newer vehicles, the stock radio is made up of several different modules spread around the vehicle. The display, controls, CD mechanism, tuner and amplifier are all separate components that communicate with each other over a network.
What vehicles use fiber optic radios?
Many European vehicles – like BMW, Porsche, Mercedes-Benz and Audi – use a fiber-optic connection between the radio and the amplifier. Aa few options will replace these amplifiers with an interface that provides full-range audio output.
